Home - Education Resources - Science of NDT - Electricity

RESISTANCE

After reading this section you will be able to do the following:

• Define resistance and how we measure it.
• Discuss the similarities between resistance in a wire and the resistance in a water hose.

There is another important property that can be measured in electrical systems. This is resistance, which is measured in units called ohms. Resistance is a term that describes the forces that oppose the flow of electron current in a conductor. All materials naturally contain some resistance to the flow of electron current. We have not found a way to make conductors that do not have some resistance.

If we use our water analogy to help picture resistance, think of a hose that is partially plugged with sand. The sand will slow the flow of water in the hose. We can say that the plugged hose has more resistance to water flow than does an unplugged hose. If we want to get more water out of the hose, we would need to turn up the water pressure at the hydrant. The same is true with electricity. Materials with low resistance let electricity flow easily. Materials with higher resistance require more voltage (EMF) to make the electricity flow.

The scientific definition of one ohm is the amount of electrical resistance that exists in an electrical circuit when one amp of current is flowing with one volt being applied to the circuit.

Is resistance good or bad?

Resistance can be both good and bad. If we are trying to transmit electricity from one place to another through a conductor, resistance is undesirable in the conductor. Resistance causes some of the electrical energy to turn into heat so some electrical energy is lost along the way. However, it is resistance that allows us to use electricity for heat and light. The heat that is generated from electric heaters or the light that we get from light bulbs is due to resistance. In a light bulb, the electricity flowing through the filament, or the tiny wires inside the bulb, cause them to glow white hot. If all the oxygen were not removed from inside the bulb, the wires would burn up.

An important point to mention here is that the resistance is higher in smaller wires. Therefore, if the voltage or EMF is high, too much current will follow through small wires and make them hot. In some cases hot enough to cause a fire or even explode. Therefore, it is sometimes useful to add components called resistors into an electrical circuit to restrict the flow of electricity and protect the components in the circuit.

Resistance is also good because it gives us a way to shield ourselves from the harmful energy of electricity. We will talk more about this on the next page.

Review

1. Resistance is the opposition to electrical current.
2. Resistance is measured in units called ohms.
3. Resistance is sometimes desirable and sometimes undesirable.